Revolutionary Crossflow Water Movement Technology
- Crossflow Technology
- Discrete Design
- Directional Twin Flow Cages
- Evenly Distributed Flow
- Gyre Generating Flows - Virtually No Dead Spots
- Controller with Mountable Cradle
- Waterproof Mounting Magnet
- 12 Month Warranty
Next Generation of Water Moving Technology
The Maxspect Gyre XF130 is the world's first "gyre"- generating water moving device for aquariums up to ~100+ gallons. Compared to traditional powerheads and wavemakers that are based on propeller nozzle flow technology, the Maxspect Gyre is based on advanced crossflow technology which produces massive horizontal water movement leaving little to no deadspots in its wake.
New -Crossflow Technology
A) Virtually no dead spots
B) Evenly distributed flow rate throughout the entire aquarium
C) Water bounces back from the other side to create a full circulation, ie. generating "gyre flows"Other Pumps
Standard Propeller Nozzle Technology
A) Dead spots with relatively poor water movement
B) Very strong flow in the center, making coral placement very difficult
C) Very weak flow near the other end of the aquarium
Why gyre generator and not wavemaker?
Wavemakers excel in making waves, while waves are spectacular to watch in motion, they are in fact moving the majority of the water vertically up and down, with relatively low horizontal movement, especially near the bottom of the aquarium.
On the other hand, gyre generators excel in moving sheer flow of water from one side of the aquarium to the other. The sheer flow of water is so strong that i would bounce back from the opposite site to achieve full circulation within an aquarium, ie. generating "gyre flows".
Maxspect XF130 Gyre
Contents: Gyre Pump with Magnet Mount, Basic Controller with mountable cradle, Power Supply, Spare Rotors and Cages.
Dimensions (LxWxH): 10 x 2.95 x 1.57
Power Supply Unit
Input Voltage / Current: 100\240vAC 50/60Hz
Output Voltage / Current: 24vDC 3A
Weight: 300g /0.7 lb
Cable Length: 2m (controller to pump), 1.5m (power supply to controller)
Magnet Holder: Clamps up to a glass thickness of 20mm (3/4in) or up to 25mm (1in) with reinforced magnet kit
*Specifications are subject to change without notice. Weight and dimensions are approximate.